3D printed Shaving Bowl

Northam Saint

Forum GOD!
Was that the abs,( I think that's the initials)?
No back to PLA. I’m going to need to make an enclosure for the printer to keep the temperature even and draft free. It’s been a right pain, but the PLA is giving a good finish.
 
S

Steve Bowles

Guest
It’s a damn shame I am a face latherer these bowl look bloody fantastic. I feel like getting one just to have one.
I don't know if you use creams at all, but I find this bowl bloody perfect for getting the creams to lather up. I face lather soaps, but a cold shaving cream on your face sucks. Give it a go, the Saint might even print one up in stainless steel colour. :thumbsup:
 

Northam Saint

Forum GOD!
I don't know if you use creams at all, but I find this bowl bloody perfect for getting the creams to lather up. I face lather soaps, but a cold shaving cream on your face sucks. Give it a go, the Saint might even print one up in stainless steel colour. :thumbsup:
I would give a warning though, not too hot water, boiling literally boiling can make it go soft, not floppy soft though, also NEVER in a microwave.
 
Top