Wolfman Darwin handle stand (Dremel needed)

carbold

Carlo
Here is my latest diy project



14mm deep socket here (you need to shorten it with an angle grinder, also you’ll have to open up the inside ever so slightly because the Darwin is a bit too tight):

https://www.ebay.co.uk/itm/S0592-Si...l-/312240971953?action=BIN&txnId=912307183021


Base from here:

https://www.ebay.co.uk/itm/5mm-Stainless-Steel-Custom-Cut-Disc-Upto-75mm-Diameter-/320958998648

Send a message to the seller and have it cut 40mm external dia with a 19.8mm internal hole

Then polish the base (don’t polish the socket, too hard!)


With a vice push the socket into the base (must go in straight).

Job done!
 
Last edited:
Top