I don't know how I missed this post! My apologies!I like the look of this, all in proportion! I have a few questions ...
Did you drill the hole yourself or was it cut when the plate was initially lasered?
Did you glue the peg in or is it just a nice tight fit?
Is that a rubber base on the base, glued?
Thank you for any illumination! I am considering a Rex and would have to have a stand to match my Feather.
I am a very slow puchaser, so not yet! Thanks for the added info about the freezer, I'll do the same when I get the Rex ... 2022 by my usual rate of knots.I don't know how I missed this post! My apologies!
When you buy the round plate you just ask them to laser cut the hole for you.
The peg is just hammered in. I put the peg in the freezer and I warmed up the plate before inserting
The rubber comes with an adhesive layer.
Did you get the Rex eventually?
Looks great!Could probably do with a soft covering on the bottom but I don't seem to have anything lying about that will do the trick right now.